product name

Troy-Bilt 2215-2228 Horse III Horse

Model: 511878

Back To Assemblies

Save
 Part Not Listed?Part Not Listed?
product name

Electric Start System - 6HP, 7HP, & 8HP Tillers

...
...
1
Cable (solenoid to starter motor) MTD-GW-96510
...
2
RUBBER BOOT- terminal insulating MTD-GW-9255
...
3
SCREW 1/4-20 X.500 one for grounding negative cable and two for mounting solenoid to bracket MTD-710-0599
...
4
BOLT- hex. hd., 5/16"-18 x 3/4", battery terminals MTD-GW-9703
...
5
HEX NUT 5/16-18 MTD-712-3010
...
6
KEYSWITCH W/DECAL (includes #20418 decal). Introduced on Tiller Serial #648406. Use with #2182 battery bracket; Replaces 1468 MTD-1900873
...
7
Label, Ignition Switch MTD-777S30648
...
8
KEY SWITCH - includes two 89243 keys, one lockwasher and one mounting nut (hardware not available separately from Garden Way) MTD-GW-9230
...
9
KEYS(1PAIR) FOR SW MTD-GW-9243099
...
10
BOLT - carriage, 1/4"-20 x 1-1/2", hold-down clamp to bracket MTD-GW-9565
...
11
Lock Washer MTD-936-0329
...
12
NUT - hex., 1/4"-20 MTD-GW-9800
...
13
Battery IMPORTANT: For Tiller Serial Nos. 685484 & Below, contact Technical Service 9123, Department regarding special battery replacement kit before ordering battery; Replaces 94878 MTD-925-1707D
...
14
SOLENOID - starter, includes all washers and nuts (Ref. No's. 15, 16, 17 & 18) for cables and wires; Replaces 9127 MTD-GW-1959
...
15
LOCK WASHER 5/16 MTD-936-0119
...
16
NUT-5/16X 24 MTD-912-3057
...
17
External Tooth Lock Washer, #10 MTD-936-0147
...
18
Hex Nut, #10-32 MTD-1186208
...
19
CABLE - solenoid to starter motor MTD-GW-9223
...
20
BATTERY BRACKET- introduced on Tiller Serial #648406. Use with 52241 clamp; Replaces 1169 MTD-GW-2182
...
21
BOLT - hex. hd., 3/8"-16 x 1-1/2", bracket to transmission cover Replaces 9713 MTD-GW-9558
...
22
L-Wash. 3/8" I.D. MTD-736-0169
...
23
TIE- twist, red plastic, wire retaining MTD-GW-9265
...
24
VENT TUBE - 5/16" dia. MTD-GW-9009
...
25
SHIELD - vent tube, 1/2" dia. MTD-GW-1475
...
26
CLAMP- vent tube shield MTD-GW-9224
...
27
7" CABLE TIE MTD-725-0157
...
28
WIRE HARNESS - for Tecumseh and Kohler engines; Includes two receptacles; three red wires (solenoid activate, battery recharge, and starter switch); one green (shutoff) wire; plastic harness tube MTD-GW-1552
...
29
CLIP-metal, supports recharging wire on Tecumseh engine MTD-GW-9218
...
30
FUSE - 6 Amperes, 3 AGC, for Tecumseh engine (earlier models only). Available locally or from Garden Way (Tecumseh x 29561) MTD-NA
...
31
DIODE - battery recharging for Tecumseh engine. For authorized service dealer replacement (Tecumseh #610935) MTD-NA
...
32
Lock Washer for Tecumseh and Kohler engines MTD-936-0329
...
33
NUT - hex., 1/4"-20 For all engines MTD-GW-9800
...
34
WIRE HARNESS - for Briggs and Stratton engine. Complete assembly only.; Includes key switch receptacle with two red wires (with eyelets), one green wire, plastic harness tube. Order red recharging wire (Ref. No. 35) separately, if needed MTD-GW-20424
...
35
WIRE-RECHARGE 5&7 BRIGGS for Briggs & Stratton engine. Includes terminal and eyelet MTD-1901894
...
36
7" CABLE TIE MTD-725-0157
...
37
LOCKWASHER - internal tooth, 1/4" Comes with engine-not avail. from Garden Way MTD-NA
...
xx
MTD-NA
...
...
...
Processing